B right and cheery Easter card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Tahitian Tide Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Basic White Cardstock
- 3-1/4" x 4" from Basic White Cardstock
- 3 pieces each 3/4" x 3-1/4" from Daffodil Delight Cardstock
- 3 pieces each 3/4" x 3-1/4" from Tahitian Tide Cardstock
Rub a Blending Brush in your choice of size across the open Parakeet Party Ink Pad to get it inky. Rub the inky Blending Brush around in a rough oval on the large, vertical white rectangle. Get more ink on the Blending Brush as needed.
Tip: I just clean my Blending Brushes when I'm done using them by running them under water until no more color is coming off. Then, I let them air dry. They may be stained, but they are clean enough to use with any color of ink in the future.
Mount the "happy Easter" sentiment from the Excellent Eggs Set on Block H. Ink it up with the Tahitian Tide Ink Pad. Stamp it on the bottom of the vertical, blended white rectangle so it is centered side to side and is about 1/2" from the bottom edge.
Adhere the stamped and blended white rectangle to the front of the Tahitian Tide card.
Pick out the zigzag die from the Excellent Eggs Dies. Put it on top of one of the Daffodil Delight strips on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces as needed. Repeat with the other two Daffodil Delight strips and the three Tahitian Tide strips.
Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the zigzag strips to the remaining, vertical white rectangle so two Tahitian Tide ones sandwich a Daffodil Delight one about 3/4" from the bottom and two Daffodil Delight ones sandwich a Tahitian Tide one about 3/4" from the top. Make sure the edges butt right up against each other in each set.
Pick out the open egg die from the Excellent Eggs Dies that cuts out an egg that is about 3-1/2" tall. Put it on top of the layered white rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Adhere the egg with zigzags cut out to the front of the card as shown.
Cut a 12" piece of the Tahitian Tide twine from the 2022-2024 In Color Baker's Twine Pack.
Fold the twine in half. Tie a small bow in the center of the folded twine. Trim the ends.
Use a squished up Mini Glue Dot to adhere the twine bow to the front of the card as shown near the left bottom of the egg.
Use the mini spatula on the Take Your Pick to carefully peel up 3 Tahitian Tide pearls from the sheet of 2022-2024 In Color Pearls making sure that you get the adhesive backings as well. Adhere them randomly to the front of the card as shown.